Pistol Smith Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
This message is directed toward Dane Burns but others may reply...I hear that Dane does a conversion of a .40 cal Kimber to 10mm...what all is done...what is the cost...what magazines are used...Also, I have visited Dane's website in the past but can't remember the address...please refresh...thanks!
 

·
Registered
Joined
·
3,831 Posts


The stainless Kimber in this picture is a 40 S&W conversion owned by a list member. I have done several more all for list members, this one a "WAVE" FED or a simple conversion to 10mm for the $200. I can supply the gun and do the conversion to 10mm for $900 plus shipping or do it on your Kimber for $200 plus shipping.

I think it is a much better gun than the orginal Colt Delta. The Kimber comes with a rramped barrel which I rechamber. I use Metalform mags.



<font size=-1>[ This Message was edited by: Dane Burns on 2001-11-21 16:16 ]</font>
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top