Pistol Smith Forum banner
1 - 2 of 2 Posts

· Registered
133 Posts
It ain't likely to happen with just a spring. If you really want 4.5# pull, a smith will have to work over your hammer & sear a bit plus refit the thumb safety after fitting the h/s. Shouldn't have to mess with the spring then. Not a real good idea anyway. Wrong approach to the job. Good luck & God bless.

<font size=-1>[ This Message was edited by: BBBBill on 2001-11-10 13:17 ]</font>
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.