Pistol Smith Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have been working on an Astra pistol, it is a baby 25 that is very old. I made the mistake of removing the mag. release and the V spring was then free to drop down - out of the pistol. What on earth must i do to get it back in? I have tried to put it in and then the sear then the hammer but the top of the V spring is too low to for the hammer to go in correctly. It is a major pain and im out of ideas. Thanks for any help ya'll can give. PAT
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top