Pistol Smith Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
579 Posts
Discussion Starter · #1 ·
Will the system work in the compact II with the firing pin safety? Dane?

I will have to drive about two hours to look at and handle any Kimbers and one dealer only had the series II in stock. Thanks! Mike
 

·
Registered
Joined
·
579 Posts
Discussion Starter · #3 ·
One more question Dane (for today :smile: ): is there any published information on the series II safety system or diagrams, et. There is no information on KimberAmerica site.

Thanks again! Mike

This is what I found under the Kimber posts! Any more information out there?
http://www.pistolsmith.com/viewtopic.ph ... orum=28&13
_________________
NRA LEAA NAHC

<font size=-1>[ This Message was edited by: Randall_1611 on 2001-11-06 15:38 ]</font>
 

·
Registered
Joined
·
3,831 Posts
Nohting I have seen, sorry. May be some one else knows and will hel p you out! It is close to the old Colt Swartz safety though if that helps. I little funky but better than the Series 80 parts IMO.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top