Pistol Smith Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
322 Posts
Discussion Starter · #1 ·
I bought a Cylinder & Slide spring steel extractor, and note that the instructions say no modifications are necessary, just proper tension, and that any mods will void the warranty. C&S installed one of their extractors in another of my guns, and it looks like they did a little bit of work on the "ramp". The unaltered extractor looks very much like a Colt, with a distinct bevel in the cam area. The C&S-installed one has had this bevel blended into a rounded contour, as is suggested by most. C&S is adamant that the extractor needs no modification. Install it and see if it works? Go ahead and do the blending?
 

·
Registered
Joined
·
1,420 Posts
How about a picture first? Then we could see what you are trying to describe... :wink:
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top