Pistol Smith Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
520 Posts
Discussion Starter · #1 ·
I have a 625-2 which has two chambers that appear to be improperly machined. Specifically, they seem to be short.

Ammo which chambers perfectly in the other four sits high in those two positions; ammo which does not seat in this gun drops perfectly into a fellow competitor's 625; and his ammo - which works fine in his gun - does not seat in mine.

Anyone else encountered this issue?
 

·
Registered
Joined
·
83 Posts
If I have the correct bullets in my pocket I like to drop them into each charge hole and observe that the projectile stays in each hole at the same depth of the others, Before I purchase a gun. A slight push with a pencil will cause it to fall out. FWIW....although I don't think this directly addresses your concern....best..dewey
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top