Pistol Smith Forum banner
1 - 1 of 1 Posts

· Registered
240 Posts
Discussion Starter · #1 ·
A friend of mine has a really neat little tool he picked up at a gun show. It is 2 pieces of
about 1/4" bar stock about 3" long with slots cut in them to put the extractor in and then pinch it like tweezers with the tools to put a little more or less spring into the extractor. It also has a little nipple on the front of one piece for pushing in the firing pin to remove the firing pin stop. It also has a little
cutout that is used to turn the extractor to the correct position after it is in the gun.
Has anyone seen this? They are the neatest little tools I have seen. I would like to buy
one but he can't remember where he got it and I can't find them.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.