Pistol Smith Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
77 Posts
Discussion Starter · #1 ·
a few weeks ago i asked about a fixture or prints to a fixture for checkering on a mill. i found one but could not afford it.
so i designed and built one of my own. i have used it once to checker the frontstrap of my stainless gold match w/ 30 lpi. it works "purdy darn good" i have a couple small "bugs" to work out but they are minor and i know how to fix them. my fixture also is adjustable to fit different radii from different manufacturers so you can get an even cut around the radius. thanks to you guys for all the help you've been on this board.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top