Pistol Smith Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter #1
Looking at a Winchester factory slug barrel for my 120 12ga pump. It is used, not abused, but does need a sight elevation ramp for the rear sight. It shoots 2 3/4 and 3in and the cost is $50 delivered to my door. Is this a good price? Also, as far as the rear sight goes, I've checked out gunpartscorp.com and all they have is for 1200 and a different one for the model 1400. Do you know if either of these two elevation ramps will interchange with the 120 Ranger? Thanks
 
G

·
Guest
Joined
·
0 Posts
wildman - get the barrel, first. Don't sweat the sight elevator. Almost any gunsmith who's been working for more than a couple of months will have a wealth of take off parts from guns he's customized, repaired or salvaged. Take your barrel around to a few shops until you find the right one. If you send me a picture once you have the barrel, I'll try to help.
 
1 - 3 of 3 Posts
Top