Pistol Smith Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
35 Posts
If you are trying to replace the beatup floorplates on the AIM FN mags, Not much luck. I have been searching for aover a year.

Best I've been able to come up with is the brass plates from brownells ($10?) but since the subplate on the military mags has a pressed out button with rounded edges, a good rap will make them slide off. The commercial mags have a subplate with a deaper and sharper through-punch with angled edges. They work great.

I also just got in a bunch of the Pearce +2 floorplates that come with their own subplate. Work fine so far.
 

·
Registered
Joined
·
10 Posts
Ken,
Try the CPMI mag pad from the Brownell's catalog. Check page 99 of the #54 catalog. stock# 153-514-100. They are black anodized aluminum, look nice and fit perfect on my 1993 production 13 round 9mm mags.
Regards,
Sonny Thompson
 

·
Registered
Joined
·
580 Posts
Not knockin' the CPMI base pads but they don't fit well on the old beater Nato mk'd mags I have, FWIW. The quality is certainly there though!
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top