Pistol Smith Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I need to remove a rear sight (the bridge type) from a High Standard Supermatic Citation. I see two blind roll pins, one on each side and one roll pin in the rear, and one pin/screw that has a head on both sides of ths sight that all hold the rear sight in place.

Does anyone know how to remove this sight without damage to the sight or the frame? Don't really care about the roll pins or the headed screw, I can make replacements on lathe.

I'm new to this forum, thanking you in advance.
 

·
Registered
Joined
·
1 Posts
High Standard Supermatic Rear Sight Removal (Bridge Type)

Rear Sight Removal (Bridge Type, part #10942)
1. remove the sear (part #10440)
2. remove the adjusting screw and plunger at the rear (part #10480, 10490)
3. drive the rear roll pin, (part #10644) to the frame
4. drive the mated large pins apart. First one by inserting a punch through the small hole in one side (part #10642). Then a larger punch to remove the second half (part #10643)
5. drive each of the side roll pins (both part #10639) in to just clear their side of the bridge
 

·
Registered
Joined
·
707 Posts
Welcome to Pistolsmith. Really good first post.
 
1 - 4 of 4 Posts
Top