Pistol Smith Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello, new poster here. Great forum, learned a lot by "lurking" for months!

I would like to thoroughly clean and get some Tetra grease on the fire control parts of my P9 (cocking cam, trigger bar where it contacts cam, etc.). Has anyone ever stripped the frame on any of the Kahr polymer pistols? Do you just use a punch to push out the pin that holds the side panel on? Any pitfalls to be aware of? Thanks in advance for any replies!
 

·
Registered
Joined
·
20 Posts
The P40 I had would start to take the pins out on it's own after about twenty rounds, then I would tap them back in. I didn't keep it long enough to have to find out how to do it on purpose.

<font size=-1>[ This Message was edited by: IRock on 2002-03-02 19:19 ]</font>
 
1 - 2 of 2 Posts
Top