Pistol Smith Forum banner
1 - 2 of 2 Posts

· Registered
90 Posts
Discussion Starter · #1 ·
Here's a silly question:
If I'm measuring for a belt, will it do just to put the gun in my pants (never mind where!) and measure all the way around with a tape measure to find the center hole?
Or is this different from what I'd get with an actual belt?

· Registered
562 Posts
Hi Youngun

I usually wear western style buckles. This worked fine for me on both styles. Measure from the end of the belt (leather only) at the buckle end to the hole that you are currently using and add two inches.

I also have the belt made with an extra hole on each side of the hole to be used.

You will also have to get you pants/jeans two inches bigger in the waist too.

B|<------Measure---->| and add 2 inches

Hope this helps.... Mike

"if guns cause crime, then pencils cause miss spelled words" NRA LEAA NAHC

<font size=-1>[ This Message was edited by: Randall_1611 on 2001-10-02 23:14 ]</font>
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.