Pistol Smith Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hi all,
new to this forum and have a question reg. triggerstop on P7. Is it possible to drill and thread direct in the trigger, or will I break it by doing this? I don´t know how the trigger looks like inside the molded plastic.
Any tips on this.
Best reg.
PBe
 
G

·
Guest
Joined
·
0 Posts
It is possible to install a stop in the trigger. HK did in fact produce a target version with an extnded barrel, oversize thumbrest grips and an add on trigger stop.
These P7 target sets are very rare.
FYI:
I have been searching and have not as of yet located a P7M8T model for sale since 1993.
 

·
Registered
Joined
·
16 Posts
Hi guys,
I in fact own a P7M13 with a trigger stop. It is a custom compensated pistol that Bruce Gray and Jim Boland (Only P7 Boland ever worked on) built together when they worked at Dean Wilkersons in Van Nuys back in the day.
 

·
Registered
Joined
·
67 Posts
If memory serves, Denny Tobin used to have one. Don't know if he would sell it even if he still has it--that was at LFI III in about 88. GLV
 
1 - 4 of 4 Posts
Top