Pistol Smith Forum banner
1 - 2 of 2 Posts

· Registered
22 Posts
Discussion Starter · #1 ·
The pin that holds the mag release assembly on my hs 2000 works out about a sixteenth of an inch after shooting a couple of boxes of ammo. The frame is polymer and the pin goes all the way through above the mag release. The gun is new and I don't want to void the warranty but I'd like to maybe fix it without shipping it back to the importer for repair. Help! Thanks, Mark.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.