Pistol Smith Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
OK Gentlemen,

I need some help (again!). I am trying to take out the ambi safety on my Kimber Pro Eclipse II.

Does anyone know how this is done? I have Jerry Kuhnhausen's book(s) on the 45 & I saw where he addressed the standard safety, but I have no idea how to get the factory ambi safety off of this pistol (I wanted to check the mating surfaces on the sear, etc.)

Any help would be appreciated!

Thanx,
Aggie
 

·
Registered
Joined
·
156 Posts
Remove the right side grip panel, then remove the right side of the ambi safety. It should just lift out, you may have to wiggle it, but don't force it! Then remove the left side of the safety as you would on any other 1911.

SF
 

·
Registered
Joined
·
9 Posts
Discussion Starter · #3 ·
OK SF,

I will try that this week, perhaps it just needs a little extra "help".

Thanks for the info and the help!
Aggie
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top