Pistol Smith Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1 (Edited)
Well, while taking apart a Rohm RG 30, a pin and 'pressure spring' fell out, but out of where both myself and my Gunsmith cannot figure it out. The customer wants his gun back now, so I turn to you, oh helpful ones.


 

·
Registered
Joined
·
1,803 Posts
It could be the spring that powers the cylinder stop or locking bolt. That's the silver "bolt" that locks into the cylinder notches.

Here's Gun Parts RG schematic section. The Model 30 is not pictured but the Model 31 appears to be similar.
Most of the RG's were pretty much the same design.

RG Accessories | Numrich Gun Parts
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Bingo!!!

Thank You! Figured it out, but it actually sits inside the cover! It holds the hand in place! But without the diagram, I wouldn't have thought to check it out. :) ;) ;) :redface:

Kent S. (Rangerbane)
 

·
Registered
Joined
·
489 Posts
Well, a happy ending, Merry Christmas. Tiny Tim gets back his $25 gun and it's not crippled anymore. :D
 
1 - 4 of 4 Posts
Top