Pistol Smith Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter · #1 ·
OK - so it's probably NOT a proper word - just one my bride came up with in a moment of glory...

Here's the deal - I have an IWB holster that I use for my P7M8 and P7M13 but with wear it has somehow loosened up to where the M13 will not stay in with any degree of certainty that it won't leap out if I jump (unlikely) or run (even more unlikely).

Is there a way to tighten up the holster again? This holster does not have a thumb break so you can see why this is rather important.

TIA--
 

·
Registered
Joined
·
849 Posts
Stephen, If it's one of ours, just send it back and we would re-mold it to tighten it up.
If it's not one of ours, I would call the manufacturer and find out if that service is available.
Doing it yourself would depend on what kind of finish was applied to the holster when it was made. Wetting it with water could ruin the holster depending on the finish.
Lou
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top