Pistol Smith Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
New guy here. Hope this is the right place to post.
I am looking for a 3 screw N frame side plate (blue)
Willing to pay$ and I have some parts to trade.
Thanks
 

·
Registered
Joined
·
5 Posts
I may have one. I picked up a side plate in a box of random stuff. I'll check it against my 28 and see if it works. It may be a k frame. I'll check
 

·
Registered
Joined
·
10 Posts
wentbig;
Remember, that these side plates were hand fitted to each individual frame.
These were finely crafted revolvers, built by master gunsmiths.
You may find an N frame side plate, but please don't be upset if the fit is not what you expected. The piece will in all likelihood have to be stoned and smoothed. (fitted)
Since the replacement part was once in another revolver, it was likely fit to that frame specifically.
 

·
Registered
Joined
·
1 Posts
rugar gp100 springs

put in a 8lb trigger spring and will not cycle, trigger will not go back hammer will not cycle, put in a 9lb spring and it all works fine (wolff)
 
1 - 4 of 4 Posts
Top