[cal.al]

Hi, i've got a problem with a cheap 1911. sometime after firing the slide stuck close. I polished about everything inside but did'nt change any parts. i was thinking about a too short sear spring jamming under the disconnector. No round is feed on this cycle and after pushing on the front of the slide it's get unstuck.Any thoughts about my issue anyone?

Envoyé de mon LG-H831 en utilisant Tapatalk

 

[cal.al]

Envoyé de mon LG-H831 en utilisant Tapatalk

 

[sigmanx]

The slide may need more fitting.

Sent from my 0PJA2 using Tapatalk

 

[hereby]

Do you feel any clicking or hesitations when you cycle the pistol without ammo? it sounds like you might have a problem related to the length of the barrel link.

 

[Combat Weapon Systems]

Take the barrel out of the slide and run the slide back and forth on the frame see if anything hangs. Then check the barrel see if its hanging on anything etc

 

[Bob Omer]

I have had my slide stick closed three times. The last time I had to use a wood clamp to get it open to where I could get
the slide stop out and remove the slide. Could not find anything wrong. Noticed the slide stop could be inserted in front
of the barrel link allowing the mainspring to push the recoil spring guide a little further back than it should. Seems to slide
well now. Going to range next week to try.

 

[Cassy0110]

I hope you fix it, but be careful

 

[Bob Omer]

Works perfect now during 3 sessions at ra range.