Pistol Smith Forum banner

1 - 14 of 14 Posts

·
Registered
Joined
·
693 Posts
Discussion Starter · #1 ·
I've garnered this curiosity from the many posts on this board. These are buried in other posts so I thought I'd bring them out. Anyone out there have the following:

A HP with Heinie scallop treatment?

A HP with Heinie SlantPro sights (not regular Heinie sights)?

Photos much appreciated please! :smile:
 

·
Registered
Joined
·
693 Posts
Discussion Starter · #7 ·
Thanks. That's a great looking HP. The SlantPro on your gun looks like it fits in a standard Novak cut -- is it different because it doesn't drop down at the back like others?
 

·
Registered
Joined
·
42 Posts
JB, great looking HP!! I especially like the type II hammer.

To be honest, I haven't seen a pic of a bad lookin HP on here yet.
 

·
Registered
Joined
·
46 Posts
HTH ? , Thank you for the link to loading photos.

Hoser - The Slant Pro was machined flush to the top
of the slide rather than dropping off the back.

The sight cut is Heinie w/o clearance cut at rear.
 

·
Registered
Joined
·
46 Posts
TFTT DD thanks for the thread

Wait hey DD what the H is a thread.

GGGGGGGEEEEEEEEEZZZZZZZZ gona havta keep the thing
on my task bar for reference.

YOUR ALL HAVING WAY TOO MUCH FUN WITH THIS.""""""""""
 

·
Registered
Joined
·
46 Posts








Test Load Photo BHP 40 Teflon Slide HC Frame
 

·
Registered
Joined
·
580 Posts
Normally don't care for "two-tone" Pistols {as if that matters} but that's one Gorgeous .40!
 

·
Registered
Joined
·
46 Posts
No Two Tones?
Must be my dark side wants glitzy hi polish stuff.
Hey but the slide matt flat black .

Got a blue out for finish be back in a few weeks
well post her.

JB
 
1 - 14 of 14 Posts
Top