Pistol Smith Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
555 Posts
Discussion Starter · #1 ·
Hey, just wanted to know is this a ramped or unramped barrel? also will it feed 40s loaded out long?? What is a good price for these.

Thanks
 

·
Registered
Joined
·
1,420 Posts
What exactly is it? I'm sure it's a 1911 type, but those letters and #s don't mean anything to me...Have you checked the web-site for this information? Good luck...SA can be contacted through the web-site or phone. They have excellent customer service as well...:wink:
 

·
Registered
Joined
·
555 Posts
Discussion Starter · #3 ·
Got emails to anyone that could answer..
its a stainless single stack loaded in 40 cal...
 

·
Registered
Joined
·
1,420 Posts
I would guess that it's ramped. I think the less than 5" get ramps and anything but a 45 gets a ramp in the 5". They run a little higher than a 45. The manager of the custom shop, Dave Williams, is often very helpful. Did you mail Dave?
Sometimes, it's easier to get a phone call answred than an e-mail.

> Deb Else
> Springfield Custom/Customer Service/Internet
>
> Springfield Inc.
> 420 West Main Street
> Geneseo, IL 61254
> (800) 680-6866
> (309) 944-3676 Fax
> [email protected]

[email protected]

These two have always answered questions and been prompt with responses...Hope this helps...

:wink:



_________________
>>>>>>>>>>>>>>>>>>>>>>g2<<<<<<<<<<<<<<<<<<<<<

..!MOLON LABE!..

<font size=-1>[ This Message was edited by: gyp_c2 on 2001-05-05 11:57 ]</font>
 

·
Registered
Joined
·
284 Posts
We have one of the Springfield 40s in stock and it is a ramped barrel. I also looked at the KimBer 40s and that gun is also ramped.

I hope this helps.
 

·
Registered
Joined
·
555 Posts
Discussion Starter · #6 ·
Thank you Terry for looking...I am going to email you to check on price and availabilty. Thanks again.
 
1 - 6 of 6 Posts
Top