[Dane Burns]

Alex.....dremel, with a cut off wheel, after a rough night :roll: Hard to get those damn lines exactly parallel though unless you hold really still!

I find a couple Darvosets helps before I start :grin:

Yes, it's CNC :wink:

<font size=-1>[ This Message was edited by: Dane Burns on 2001-07-09 19:09 ]</font>

 

[Guest]

Public Service Anouncement:
Warning, do not try this at home.

All kidding aside do not cut your frames with a dremel attempting to make the "wave".

Although the replacment frame makers could surely use your money.....

 

[Just a GI]

Speaking of G/S, is that a cut down Brown? The "wave" is growing on me, but my eyes are getting blurry :smile: . Ya think if I have a couple of drinks that will fix it? :grin:

 

[Dane Burns]

Speaking of G/S, is that a cut down Brown?

Yes....

 

[Mute]

On 2001-07-09 18:12, Dane Burns wrote:
Alex.....dremel, with a cut off wheel, after a rough night :roll: Hard to get those damn lines exactly parallel though unless you hold really still!

I find a couple Darvosets helps before I start :grin:

Yes, it's CNC :wink:

<font size=-1>[ This Message was edited by: Dane Burns on 2001-07-09 19:09 ]</font>

I was just thinking your were checkering by hand here in CA. and happen to get hit by a 6.0. :grin: