Pistol Smith Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
218 Posts
I rework BHP all over the country. It is not as easy as some would have you believe. My triggers break a 4 3/4 lbs. All my engagements are checked on a microscope. I do things different than the average gunsmith. I do not and will not take any short cuts, as most all my work is used for protection of life and property. I require a written authorization allowing me to remove the magazine safety. Hi Powers I have done have been featured in many national magazines. For any information contact me.

Teddy Jacobson / pistolsmith
http://www.actionsbyt.com
281 277 4008
 

· Registered
Joined
·
218 Posts
If some of you think trigger work is so easy. I have a question for you. CAN YOU TAKE A SEMI AUTO PISTOL WITH A DOUBLE ACTION PULL OF 15 LBS LETS say its a CZ OR A USP OR WHATEVER AND REDUCE THE FACTORY DA TO 8 3/4 LBS, BUT THE FACTORY SINGLE ACTION IS 4 LBS BUT I WANT TO INCREASE IT TO 5 1/2 lbs. NO SPRINGS ARE TO BE CUT JUST USE FULL COIL WOLFF SPRINGS, AND DO NOT PACK THE GUN FULL OF GREASE QUESTION IS AGAIN CAN YOU DO IT?????????????????
IT CAN BE DONE..................................................
I do use a MICROSCOPE

Teddy Jacobson / pistolsmith
http://www.actionsbyt.com
281 277 4008
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top