Pistol Smith Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
403 Posts
I like the Dlask trigger medium length, mated to a nice hammer and sear from A6. A lightweight hammer with side relief, and the sear with a full half cock notch.

More importantly Dane let me ask you something. What hammer hook angle do you prefer. You like the 90 degree, the print 86 degree, or something in between? What about hammer hook height, and sear engagement remaining after the relief angle is cut.

I like to get to the nitty gritty of things.

So far I like .025 height hammer hooks at 88 degrees and .020 sear engagment. For a general use carry gun, target gun I haven't played with yet.

_________________
if it flies it dies, if it runs it's done

<font size=-1>[ This Message was edited by: Peter Zahn on 2001-04-23 09:34 ]</font>

<font size=-1>[ This Message was edited by: Peter Zahn on 2001-04-23 09:38 ]</font>
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top