Pistol Smith Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
260 Posts
Discussion Starter · #1 ·
If you were going to install all new innards in a Commander, to include trigger and both safetys, in what order would you install them? I have always replaced the hammer and sear, then the grip safety and them the thumb safety, in that order. Is this right? Thanks.

Wayne
 

·
Registered
Joined
·
322 Posts
If you don't install the new safeties at the same time you do the internals, you'll probably have to refit the stock parts anyway (if they even can be refit to the new hammer/sear); why do it twice?
 

·
Registered
Joined
·
239 Posts
Trigger first. Then do hammer/sear, to include setting weight of sear spring. The function fitting of the grip and thumb safeties are independent, so it doesn't matter in what order you do them. You can fit the GS w/o the hammer/sear in place, using the TS to hold in place. You can fit the TS w/o the GS functioning or even in place.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top