Pistol Smith Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
207 Posts
Discussion Starter · #1 ·
Some one gave me two Wilson stainless magazines. Last night I tried to clean them but was unable to remove the follower. I'd hate to spray gun scrubber in the tube while the follower is still in there. How do you do it? Also, can I get a rebuild kit for them, spring, follower, etc? Thanks, Sam :???:
 

·
Registered
Joined
·
207 Posts
If you have removed the basepad, floor plate, and spring, the follower should be loose inside the mag body. Try to turn the follower vertical and remove it from the front of the feed lips. Use a pair of small pliers or tweezers to get a hold of the follower if you're having trouble.

Wilson and Brownells sales a rebuild kit for about $7 a piece. If the mags are giving you trouble, Wilson will replace them for free.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top